Leviton Network Router 47611 GB4 User Manual

IMPORTANT INSTRUCTIONS  
1. Read and understand all instructions. Follow all warnings and instructions marked  
on the product.  
2. Do not use this product near water—e.g., near a tub, wash basin, kitchen sink or  
laundry tub, in a wet basement, or near a swimming pool.  
3. Never push objects of any kind into this product through openings, as they may  
touch dangerous voltages.  
4. SAVE THESE INSTRUCTIONS.  
47611-GB4  
Quick-Start Guide  
SAFETY INFORMATION  
10/100/1000 Mbps 4-Port Gigabit Router  
1. Never install communications wiring or components during a lightning storm.  
The 10/100/1000 Mbps 4-Port Gigabit Router is an easy-to-use router that offers small  
office and home office (SOHO) an economical way to connect an entire local area  
network (LAN) to the Internet using an external DSL/Cable Modem.  
2. Never install communications components in wet locations unless the components  
are designed specifically for use in wet locations.  
3. Never touch uninsulated wires or terminals unless the wiring has been disconnected  
Follow this Quick-Start Guide to mount the Router into your Structured Media™ Center  
(SMC), and configure it for normal network operation.  
at the network interface.  
4. Use caution when installing or modifying communications wiring or components.  
PRE-INSTALLATION CHECKLIST  
To install the Router, you must have the following:  
• A network interface card (NIC) installed in your computer. (Gigabit network card  
required for gigabit speeds to be attained.)  
• An external Cable or DSL modem with an RJ-45 port.  
• (4) patch cords with RJ-45 connectors. Leviton Category 5e Performance Patch  
Cords are recommended.  
• A Leviton Category 5e or Category 6 Voice and Data Module located in an SMC.  
• At least 2 Category 5e or Category 6 data connectors (in addition to any desired  
telephone jacks), wired back to the Category 5e Voice and Data Module with  
Category 5e cable. Mark these two connectors and corresponding ports “A” and “B”.  
(Figure 2, page 5)  
• An operational Internet connection/ISP.  
• A Web browser installed on your computer.  
• Specific ISP information for your broadband connection service; including: type of  
protocol (PPPoE, Dynamic IP, or Fixed IP) and pertinent login information.  
NOTE: Category 5e or Category 6 products are required for gigabit operation.  
For Technical Assistance Call:  
1-800-824-3005 (U.S.A. Only)  
or Fax:  
1-800-824-9538 (U.S.A. Only)  
59-25 Little Neck Parkway.  
Little Neck, N.Y. 11362-2591, USA  
Tech Support: 800-824-3005  
DI-045-47611-05A  
1
 
4. Use one of the four Performance Patch Cords to connect the computer’s Ethernet  
Client Notes  
port to the data connector marked “B”.  
5. At the SMC, locate the Router port marked WAN. Use the second Performance  
Patch Cord to connect this WAN port to the Category 5e Voice and Data Module  
port marked “A”. This is the port linked back to the modem’s data connector.  
6. Use the third Performance Patch Cord to connect one of the Router ports (labeled  
1-4) to the Category 5e Voice & Data Module port marked “B”. This is the port that is  
linked back to the computer’s data connector.  
NOTE: To connect up to three additional computers or peripherals, simply connect  
the Router’s other numbered ports to Category 5e Voice & Data Module ports,  
which in turn are cabled back to additional data connectors at the computer or  
peripheral location.  
7. Reconnect the power to the modem, ensure your modem is connected to your  
broadband service. (Phone service can be run through your Voice & Data Module,  
as seen in Figure 2, page 5.)  
8. Attach the power cord to the Router and plug it into an AC outlet, powering the  
Router.  
9. Restart your computer.  
Configuring the Router:  
browser window. This is the default IP address for the Router. This IP address  
connects to the Router firmware, not the Internet.  
2. Once the Router firmware is contacted, you should see a prompt for a user name  
and password. Leave the user name field blank and type “leviton” in lower case in the  
password field. The password is case sensitive; do not include the quotation marks.  
3. Click “OK”.  
4. Select the “Setup Wizard” on the left frame of page. You will be guided through a  
series of questions to configure your Router.  
NOTE: You will need your connection information from your ISP.  
NOTE: If it’s necessary to return the Router to its factory default settings, press and  
hold the “reset” button on the back of the module for six seconds.  
If you need additional assistance, please call Leviton’s Technical Support at  
1-800-824-3005.  
6
DI-045-47611-05A  
DI-045-47611-05A  
3
 
FCC STATEMENT:  
Figure 2  
This equipment has been tested and found to comply with the limits for a Class B  
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency energy and, if not  
installed and used in accordance with the instructions, may cause harmful interference  
to radio communications. However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause harmful interference to  
radio or television reception, which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the interference by one or more of the  
following measures:  
Inside the SMC  
CAT 5e  
From DSL filter module  
(”out to modem” jack)  
Internet Gateway  
• Reorient or relocate the receiving antenna.  
WAN  
4
3
2
1
Category 5e Voice  
& Data Module  
Category 5e  
Jack 1  
• Increase the separation between the equipment and receiver.  
PWR  
2
1
• Connect the equipment into an outlet on a circuit different from that to which the  
receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for help.  
CAT 5e  
CAT 5e Patch Cord  
CAT 5e Patch Cord  
CAT 5e  
6
5
Jack 6  
CAT 5e  
AC Power Module  
DSL Modem  
CAT 5e Patch Cord  
Phone LIne  
CAT 5e Patch Cord  
Wallplate  
NIC  
Computer  
4
DI-045-47611-05A  
DI-045-47611-05A  
5
 
11.0"  
This page is NOT to be printed in the booklet  
LEVITON INSTRUCTION SHEET/MANUAL  
SPECIFICATIONS  
Saddle  
Stitch  
DI-045-47611-05A  
8.5"  
Black  
Helvetica  
2
3
50 lb. offset  
OVERALL SIZE  
5.5"  
Paper size:  
11" x 8.5" (Printer Spread)  
Overall size:  
5.5" x 8.5" (booklet - saddle stitch)  
Final fold size:  
Cat. No.  
DOCUMENTATION  
N/A  
HSZ  
03/08/07  
8.5"  
Booklet  
1
FINAL SIZE  
 

KWC Outdoor Shower K269910000 User Manual
Lenovo Computer Monitor 5047HC2 User Manual
Lenovo Tablet 59368543 User Manual
Lenoxx Electronics Furnace O23V User Manual
Liebherr Refrigerator 7082 212 02 User Manual
Life Fitness Elliptical Trainer 9100R User Manual
Louisville Tin and Stove Furnace 90N30A User Manual
Mace DVR DVR 9416 User Manual
Marley Engineered Products Ventilation Hood 898L User Manual
Maverick Ventures Thermometer ET 41 User Manual